Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 626)

570 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
26
OAM Commands
efm oam
This command enables OAM functions on the specified port. Use the no form to disable this
function.
Syntax
[no] efm oam
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
• If the remote device also supports OAM, both exchange Information OAMPDUs to establish an
OAM link.
• Not all CPEs support OAM functions, and OAM is therefore disabled by default. If the CPE
attached to a port supports OAM, then this functionality must first be enabled by the efm oam
command to gain access to other remote configuration functions.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam
Console(config-if)#
efm oam critical-link-event
This command enables reporting of critical event or dying gasp. Use the no form to disable this
function.
Syntax
[no] efm oam critical-link-event {critical-event | dying-gasp}
critical-event - If a critical event occurs, the local OAM entity (this switch) indicates this to
its peer by setting the appropriate flag in the next OAMPDU to be sent and stores this
information in its OAM event log.
dying-gasp - If an unrecoverable condition occurs, the local OAM entity indicates this by
immediately sending a trap message.
Default Setting
Enabled
Command Mode
Interface Configuration
Command Usage
• Critical events are vendor-specific and may include various failures, such as abnormal voltage
fluctuations, out-of-range temperature detected, fan failure, CRC error in flash memory,
insufficient memory, or other hardware faults.