Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 216)

160 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
9
Web Server
Command Mode
Global Configuration
Example
Console(config)#ip http server
Console(config)#
Related Commands
“ip http port” on page 159
“show system” on page 62
ip http secure-port
This command specifies the UDP port number used for HTTPS connection to the switch’s web
interface. Use the no form to restore the default port.
Syntax
ip http secure-port port_number
no ip http secure-port
port_number – The UDP port used for HTTPS. (Range: 1-65535)
Default Setting
443
Command Mode
Global Configuration
Command Usage
• You cannot configure the HTTP and HTTPS servers to use the same port.
• If you change the HTTPS port number, clients attempting to connect to the HTTPS server must
specify the port number in the URL, in this format: https://device:port_number
Example
Console(config)#ip http secure-port 1000
Console(config)#
Related Commands
“ip http secure-server” on page 160
“show system” on page 62
ip http secure-server
This command enables the secure hypertext transfer protocol (HTTPS) over the Secure Socket
Layer (SSL), providing secure access (i.e., an encrypted connection) to the switch’s web interface.
Use the no form to disable this function.
Syntax
[no] ip http secure-server