Table 41 – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 217
Brocade 6910 Ethernet Access Switch Configuration Guide
161
53-1002651-02
9
Web Server
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
•
Both HTTP and HTTPS service can be enabled independently on the switch. However, you
cannot configure the HTTP and HTTPS servers to use the same UDP port.
•
If you enable HTTPS, you must indicate this in the URL that you specify in your browser:
https://device[:port_number]
•
When you start HTTPS, the connection is established in this way:
•
The client authenticates the server using the server’s digital certificate.
•
The client and server negotiate a set of security protocols to use for the connection.
•
The client and server generate session keys for encrypting and decrypting data.
•
The client and server establish a secure encrypted connection.
A padlock icon should appear in the status bar for Internet Explorer 6.x or above, and Mozilla
Firefox 3.6.2/4/5.
The following web browsers and operating systems currently support HTTPS:
•
To specify a secure-site certificate, see
“Replacing the Default Secure-site Certificate”
tftp https-certificate
command.
Example
Console(config)#ip http secure-server
Console(config)#
Related Commands
copy
tftp https-certificate
)
TABLE 41
HTTPS System Support
Web Browser
Operating System
Internet Explorer 6.x or later
Windows 98,Windows NT (with service pack 6a), Windows 2000,
Windows XP, Windows Vista, Windows 7
Mozilla Firefox 3.6.2/4/5
Windows 2000, Windows XP, Linux