Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 246)

190 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
10
Port Security
port security
This command enables or configures port security. Use the no form without any keywords to
disable port security. Use the no form with the appropriate keyword to restore the default settings
for a response to security violation or for the maximum number of allowed addresses.
Syntax
port security [action {shutdown | trap | trap-and-shutdown} | max-mac-count address-count]
no port security [action | max-mac-count]
action - Response to take when port security is violated.
shutdown - Disable port only.
trap - Issue SNMP trap message only.
trap-and-shutdown - Issue SNMP trap message and disable port.
max-mac-count
address-count - The maximum number of MAC addresses that can be learned on a
port. (Range: 0 - 1024, where 0 means disabled)
Default Setting
Status: Disabled
Action: None
Maximum Addresses: 0
Command Mode
Interface Configuration (Ethernet)
Command Usage
• The default maximum number of MAC addresses allowed on a secure port is zero (that is, port
security is disabled). To use port security, you must configure the maximum number of
addresses allowed on a port using the port security max-mac-count command.
• When port security is enabled using the port security command, or the maximum number or
allowed addresses is set to value lower than the current limit after port security has been
enabled, the switch first clears all dynamically learned entries from the address table. It then
starts learning new MAC addresses on the specified port, and stops learning addresses when
it reaches a configured maximum number. Only incoming traffic with source addresses already
stored in the dynamic or static address table will be accepted.
TABLE 48 Management IP Filter Commands
Command Function Mode
mac-address-table static Maps a static address to a port in a VLAN GC
port security Configures a secure port IC
show mac-address-table Displays entries in the bridge-forwarding database PE
show port security Displays port security status and secure address count PE