Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 259)

Brocade 6910 Ethernet Access Switch Configuration Guide 203
53-1002651-02
10
Network Access (MAC Address Authentication)
mac- authentication max-mac-count
Use this command to set the maximum number of MAC addresses that can be authenticated on a
port via MAC authentication. Use the no form of this command to restore the default.
Syntax
mac-authentication max-mac-count count
no mac-authentication max-mac-count
count - The maximum number of MAC-authenticated MAC addresses allowed.
(Range: 1-1024)
Default Setting
1024
Command Mode
Interface Configuration
Example
Console(config-if)#mac-authentication max-mac-count 32
Console(config-if)#
clear network-access
Use this command to clear entries from the secure MAC addresses table.
Syntax
clear network-access mac-address-table [static | dynamic]
[address mac-address] [interface interface]
static - Specifies static address entries.
dynamic - Specifies dynamic address entries.
mac-address - Specifies a MAC address entry. (Format: xx-xx-xx-xx-xx-xx)
interface - Specifies a port interface.
ethernet unit/port
unit - This is unit 1.
port - Port number. (Range: 1-12)
Default Setting
None
Command Mode
Privileged Exec
Example
Console#clear network-access mac-address-table interface ethernet 1/1
Console#