Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 379)

Brocade 6910 Ethernet Access Switch Configuration Guide 323
53-1002651-02
Chapter
17
Address Table Commands
In this chapter
These commands are used to configure the address table for filtering specified addresses,
displaying current entries, clearing the table, or setting the aging time.
mac-address-table aging-time
This command sets the aging time for entries in the address table. Use the no form to restore the
default aging time.
Syntax
mac-address-table aging-time seconds
no mac-address-table aging-time
seconds - Aging time. (Range: 10-844 seconds; 0 to disable aging)
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The aging time is used to age out dynamically learned forwarding information.
Example
Console(config)#mac-address-table aging-time 100
Console(config)#
TABLE 75 Address Table Commands
Command Function Mode
mac-address-table
aging-time Sets the aging time of the address table GC
mac-address-table static Maps a static address to a port in a VLAN GC
clear mac-address-table
dynamic Removes any learned entries from the forwarding
database PE
show mac-address-table Displays entries in the bridge-forwarding database PE
show mac-address-table
aging-time Shows the aging time for the address table PE
show mac-address-table
count Shows the number of MAC addresses used and the
number of available MAC addresses PE