Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 706)

650 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
31
Debug Commands
1001 10001 0 0 0 0 0 0 0 0
Console#
debug msl show-interface-info
This command shows the status of all Multicast Shim Layer (MSL) VLAN interfaces.
Syntax
debug msl show-interface-info
Command Mode
Privileged Exec
Example
Console#debug msl show-interface-info
interface vid:1, bridge id:0, vrf id:0, Flags : SNP_ACTIVE,
all member port : 1, 2, 3, 4, 6, 7, 8, 9, 10, 11, 12,
router port list:
interface vid:5, bridge id:0, vrf id:0, Flags : SNP_ACTIVE,
all member port : 5,
router port list:
Console#
debug msl show-mrt-info
This command shows the status of all Multicast Routing (MRT) interfaces.
Syntax
debug msl show-mrt-info
Command Mode
Privileged Exec
Example
Console#debug msl show-mrt-info
Group: 225.1.1.1, Source: 0.0.0.0, Upstream VLAN: 0, rp: 0
Flags: , SNP, , , , Hit Bit: 0
Snooping interface:
L2 interface: 1(Flags : CHIP,,,) port:1,
L2 interface: 5(Flags : CHIP,,,) port:5,
Multicast downstream interface:
MVR downstream interface:
Group: 225.1.1.3, Source: 0.0.0.0, Upstream VLAN: 0, rp: 0
Flags: , SNP, , , , Hit Bit: 0
Snooping interface:
L2 interface: 1(Flags : CHIP,,,) port:1,
Multicast downstream interface:
MVR downstream interface: