Spanning-tree hello-time, Spanning-tree max-age, Spanning-tree hello-time spanning-tree max-age – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 388

332
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
18
Spanning Tree Commands
Example
Console(config)#spanning-tree forward-time 20
Console(config)#
spanning-tree hello-time
This command configures the spanning tree bridge hello time globally for this switch. Use the no
form to restore the default.
Syntax
spanning-tree hello-time time
no spanning-tree hello-time
time - Time in seconds. (Range: 1-10 seconds).
The maximum value is the lower of 10 or [(max-age / 2) - 1].
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
This command sets the time interval (in seconds) at which the root device transmits a configuration
message.
Example
Console(config)#spanning-tree hello-time 5
Console(config)#
Related Commands
spanning-tree max-age
This command configures the spanning tree bridge maximum age globally for this switch. Use the
no form to restore the default.
Syntax
spanning-tree max-age seconds
no spanning-tree max-age
seconds - Time in seconds. (Range: 6-40 seconds)
The minimum value is the higher of 6 or [2 x (hello-time + 1)].
The maximum value is the lower of 40 or [2 x (forward-time - 1)].
Default Setting
20 seconds