Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 193)

Brocade 6910 Ethernet Access Switch Configuration Guide 137
53-1002651-02
8
Flow Sampling Commands
sflow sample
This command configures the packet sampling rate. Use the no form to restore the default rate.
Syntax
sflow sample rate
no sflow sample
rate - The packet sampling rate, or the number of packets out of which one sample will be
taken. (Range: 256-16777215 packets)
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
This example sets the sample rate to 1 out of every 100 packets.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow sample 100
Console(config-if)#
sflow source
This command enables sFlow on the source ports to be monitored. Use the no form to disable
sFlow on the specified ports.
Syntax
[no] sflow source
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
This example enables flow control on ports 9 through 16.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow source
Console(config-if)#