Show running-config – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 116
60
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
5
System Status
show running-config
This command displays the configuration information currently in use.
Syntax
show running-config [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
vlan vlan-id (Range: 1-4093)
Command Mode
Privileged Exec
Command Usage
•
Use the interface keyword to display configuration data for the specified interface.
•
Use this command in conjunction with the show startup-config command to compare the
information in running memory to the information stored in non-volatile memory.
•
This command displays settings for key command modes. Each mode group is separated by “!”
symbols, and includes the configuration mode command, and corresponding commands. This
command displays the following information:
•
MAC address for the switch
•
SNMP community strings
•
Users (names, access levels, and encrypted passwords)
•
VLAN database (VLAN ID, name and state)
•
VLAN configuration settings for each interface
•
Multiple spanning tree instances (name and interfaces)
•
Interface settings and VLAN configuration settings for each interface
•
IP address configured for management VLAN
•
Any configured settings for the console port and Telnet
Example
Console#show running-config
Building startup configuration. Please wait...
!
!
!
l2protocol-tunnel tunnel-dmac 01-12-cf-00-00-00
!
snmp-server community public ro
snmp-server community private rw
!
snmp-server enable traps authentication
!