Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 149)

Brocade 6910 Ethernet Access Switch Configuration Guide 93
53-1002651-02
5
Time
SMTP destination email addresses
-----------------------------------------------
[email protected]
SMTP Source Email Address: [email protected]
SMTP Status: Enabled
Console#
Time
The system clock can be dynamically set by polling a set of specified time servers (NTP or SNTP).
Maintaining an accurate time on the switch enables the system log to record meaningful dates and
times for event entries. If the clock is not set, the switch will only record the time from the factory
default set at the last bootup.
SNTP Commands
sntp client
This command enables SNTP client requests for time synchronization from NTP or SNTP time
servers specified with the
sntp server command. Use the no form to disable SNTP client requests.
Syntax
[no] sntp client
Default Setting
Disabled
TABLE 23 Time Commands
Command Function Mode
SNTP Commands
sntp client Accepts time from specified time servers GC
sntp poll Sets the interval at which the client polls for time GC
sntp server Specifies one or more time servers GC
show sntp Shows current SNTP configuration settings NE, PE
Manual Configuration Commands
clock summer-time (date) Configures summer time * for the switch’s internal clock
* Daylight savings time.
GC
clock summer-time
(predefined) Configures summer time * for the switch’s internal clock GC
clock summer-time
(recurring) Configures summer time * for the switch’s internal clock GC
clock timezone Sets the time zone for the switch’s internal clock GC
calendar set Sets the system date and time PE
show calendar Displays the current date and time setting NE, PE