Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 215)

Brocade 6910 Ethernet Access Switch Configuration Guide 159
53-1002651-02
9
Web Server
Web Server
This section describes commands used to configure web browser management access to the
switch.
ip http port
This command specifies the TCP port number used by the web browser interface. Use the no form
to use the default port.
Syntax
ip http port port-number
no ip http port
port-number - The TCP port to be used by the browser interface. (Range: 1-65535)
Default Setting
80
Command Mode
Global Configuration
Example
Console(config)#ip http port 769
Console(config)#
Related Commands
“ip http server” on page 159
“show system” on page 62
ip http server
This command allows this device to be monitored or configured from a browser. Use the no form to
disable this function.
Syntax
[no] ip http server
Default Setting
Enabled
TABLE 40 Web Server Commands
Command Function Mode
ip http port Specifies the port to be used by the web browser interface GC
ip http server Allows the switch to be monitored or configured from a browser GC
ip http secure-port Specifies the UDP port number for HTTPS GC
ip http secure-server Enables HTTPS (HTTP/SSL) for encrypted communications GC