beautypg.com

Ethernet cfm delay-measure destination, Table 133 – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 611

background image

Brocade 6910 Ethernet Access Switch Configuration Guide

555

53-1002651-02

25

CFM Commands

ethernet cfm delay-measure destination

This command sets the destination MEP identifier or MAC address for periodically transmitted
delay-measure messages. Use the no form to clear a destination.

Syntax

ethernet cfm delay-measure destination dest-mep {destination-mpid | destination-mac}

md domain-name ma ma-name mpid source-mpid

no ethernet cfm delay-measure destination md domain-name ma ma-name mpid mpid

destination-mpid – The identifier of a remote MEP that is the target of the delay-measure
message. (Range: 1-8191)

destination-mac – MAC address of a remote MEP that is the target of the delay-measure
message. This must be the unicast address. A multicast MAC address cannot be used.
This address can be entered in either of the following formats: xx-xx-xx-xx-xx-xx or
xxxxxxxxxxxx

domain-name – Domain name. (Range: 1-43 alphanumeric characters)

ma-name – Maintenance association name. (Range: 1-43 alphanumeric characters,
maximum length is 44 minus the length of the domain name)

source-mpid – Maintenance end point identifier of a local MEP that is the source of the
delay measure message. (Range: 1-8191)

Default Setting
None

Command Mode
Global Configuration

Command Usage
To modify settings for a destination, first disable the transmission of periodic delay-measure
messages with the

no ethernet cfm delay-measure enable

command.

Example
This example sets the periodic delay-measure message destination for a MEP.

Console(config)#ethernet cfm delay-measure destination dest-mep 2 md voip ma rd

mpid 1

Console(config)#