Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 744)

688 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
33
Setting the System Clock
Interface
To manually set the system clock:
1. Click System, then Time.
2. Select Configure General from the Step list.
3. Select Manual from the Maintain Type list.
4. Enter the time and date in the appropriate fields.
5. Click Apply
FIGURE 19 Manually Setting the System Clock
Setting the SNTP Polling Interval
Use the System > Time (Configure General - SNTP) page to set the polling interval at which the
switch will query the specified time servers.
CLI References
• “Time” on page 93
Parameters
The following parameters are displayed:
• Current Time – Shows the current time set on the switch.
• SNTP Polling Interval – Sets the interval between sending requests for a time update from a
time server. (Range: 16-16384 seconds; Default: 16 seconds)
Interface
To set the polling interval for SNTP:
1. Click System, then Time.
2. Select Configure General from the Step list.
3. Select SNTP from the Maintain Type list.
4. Modify the polling interval if required.
5. Click Apply