Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 436)

380 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
20
Configuring VLAN Interfaces
Example
The following example shows how to add VLANs 1, 2, 5 and 6 to the allowed list as tagged VLANs
for port 1:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport allowed vlan add 1,2,5,6 tagged
Console(config-if)#
switchport ingress-filtering
This command enables ingress filtering for an interface. Use the no form to restore the default.
Syntax
[no] switchport ingress-filtering
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Ingress filtering only affects tagged frames.
• If ingress filtering is disabled and a port receives frames tagged for VLANs for which it is not a
member, these frames will be flooded to all other ports (except for those VLANs explicitly
forbidden on this port).
• If ingress filtering is enabled and a port receives frames tagged for VLANs for which it is not a
member, these frames will be discarded.
• Ingress filtering does not affect VLAN independent BPDU frames, such as GVRP or STA.
However, they do affect VLAN dependent BPDU frames, such as GMRP.
Example
The following example shows how to set the interface to port 1 and then enable ingress filtering:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport ingress-filtering
Console(config-if)#