Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1231)

Brocade 6910 Ethernet Access Switch Configuration Guide 1175
53-1002651-02
configuration settings
restoring , 23 , 66 , 67 , 681 , 682
saving , 23 , 66 , 67 , 681
Connectivity Fault Management See CFM
console port, required connections
, 12
continuity check errors, CFM , 540 , 541 , 1036
continuity check messages, CFM , 363 , 517 , 537 , 538 ,
992 , 994 , 995
CoS , 423 , 815
configuring , 415 , 815
default mapping to internal values , 420 , 824
enabling , 423 , 821
layer 3/4 priorities , 419 , 821
priorities, mapping to internal values , 420 , 824
queue mapping , 423 , 819
queue mode , 416 , 816
queue weights, assigning , 417 , 817
CoS/CFI to PHB/drop precedence , 420 , 824
CPU
status , 59 , 696
utilization, showing , 59 , 696
CPU utiilzation, setting trap , 123
Craft port , 13 , 596 , 597 , 607 , 612 , 622
interface selection , 256 , 257
IPv4 address, configuring , 596 , 597
IPv6 address, configuring , 607
IPv6 address, zone ID , 622
IPv6 interface, enabling , 612
cross-check errors, CFM , 539 , 543 , 544
cross-check message, CFM , 517 , 542 , 543 , 544 , 545 ,
992 , 995
cross-check start delay, CFM , 542 , 995
CVLAN to SPVLAN map , 387 , 764
D
default IPv4 gateway, configuration , 597 , 1078
default IPv6 gateway, configuration , 606 , 1051
default priority, ingress port , 418 , 815
default settings, system , 8
delay measure request, CFM , 559 , 560 , 1021
delay measure request, one-way, CFM , 559 , 1021
delay measure request, two-way, CFM , 560 , 1021
DHCP , 596 , 1048 , 1087
class identifier , 588 , 1087
client , 587 , 596 , 1048
client identifier , 588 , 1087
dynamic configuration , 17
relay service , 592 , 1088
relay service, restarting , 593 , 1088
DHCP snooping , 211 , 926
enabling , 212 , 927
global configuration , 212 , 927
information option , 213 , 928
information option policy , 215 , 928
information option, enabling , 213 , 928
policy selection , 215 , 928
specifying trusted interfaces , 218 , 930
verifying MAC addresses , 215 , 928
VLAN configuration , 216 , 929
Differentiated Code Point Service See DSCP
Differentiated Services See DiffServ
DiffServ
, 427 , 827
binding policy to interface , 440 , 839
class map , 428 , 431 , 828
class map, description , 429
classifying QoS traffic , 429 , 828
color aware, srTCM , 434 , 835
color aware, trTCM , 436 , 835
color blind, srTCM , 434 , 835
color blind, trTCM , 436 , 835
committed burst size , 432 , 434 , 436 , 834 , 835 , 836
committed information rate , 432 , 434 , 436 , 834 , 835
configuring , 427 , 827
conforming traffic, configuring response , 432 , 434 ,
436 , 834
description , 429
excess burst size , 434 , 835
metering, configuring , 432 , 831 , 832
peak burst size , 436 , 836
peak information rate , 436 , 836
policy map , 431 , 831
policy map, description , 429 , 828 , 833
QoS policy , 431 , 831
service policy , 440 , 839
setting CoS for matching packets , 438 , 834
setting IP DSCP for matching packets , 439 , 834
setting PHB for matching packets , 439 , 834
single-rate, three-color meter , 434 , 831 , 834
srTCM metering , 434 , 831 , 834
traffic between CIR and BE, configuring response , 434 ,
834
traffic between CIR and PIR, configuring response ,
436 , 835
trTCM metering , 436 , 835
two-rate, three-color meter , 436 , 832
violating traffic, configuring response , 432 , 434 , 436 ,
836
DNS
default domain name , 581 , 1081
displaying the cache , 585 , 1086