Hostname, Banner information, Table 12 – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 104

48
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
5
Banner Information
hostname
This command specifies or modifies the host name for this device. Use the no form to restore the
default host name.
Syntax
hostname name
no hostname
name - The name of this host. (Maximum length: 255 characters)
Default Setting
None
Command Mode
Global Configuration
Example
Console(config)#hostname RD#1
Console(config)#
Banner Information
These commands are used to configure and manage administrative information about the switch,
its exact data center location, details of the electrical and network circuits that supply the switch,
as well as contact information for the network administrator and system manager. This information
is only available via the CLI and is automatically displayed before login as soon as a console or
telnet connection has been established.
TABLE 12
Banner Commands
Command
Function
Mode
Configures the banner information that is displayed before login
GC
Configures the Company information that is displayed by banner
GC
banner configure
dc-power-info
Configures the DC Power information that is displayed by banner
GC
Configures the Department information that is displayed by banner
GC
banner configure
equipment-info
Configures the Equipment information that is displayed by banner
GC
banner configure
equipment-location
Configures the Equipment Location information that is displayed by
banner
GC
Configures the IP and LAN information that is displayed by banner
GC
Configures the LP Number information that is displayed by banner
GC
Configures the Manager contact information that is displayed by
banner
GC
Configures the MUX information that is displayed by banner
GC