Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 133)

Brocade 6910 Ethernet Access Switch Configuration Guide 77
53-1002651-02
5
Line
exec-timeout
This command sets the interval that the system waits until user input is detected. Use the no form
to restore the default.
Syntax
exec-timeout [seconds]
no exec-timeout
seconds - Integer that specifies the timeout interval. (Range: 1 - 65535 seconds; 600
seconds)
Default Setting
CLI: No timeout
Telnet: 10 minutes
Command Mode
Line Configuration
Command Usage
• If user input is detected within the timeout interval, the session is kept open; otherwise the
session is terminated.
• This command applies to both the local console and Telnet connections.
• The timeout for Telnet cannot be disabled.
• Using the command without specifying a timeout restores the default setting.
Example
To set the timeout to two minutes, enter this command:
Console(config-line)#exec-timeout 120
Console(config-line)#
login
This command enables password checking at login. Use the no form to disable password checking
and allow connections without a password.
Syntax
login [local]
no login
local - Selects local password checking. Authentication is based on the user name
specified with the
username command.
Default Setting
login local
Command Mode
Line Configuration