General commands, Boot system, Table 15 – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 122
66
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
5
File Management
When downloading runtime code, the destination file name can be specified to replace the current
image, or the file can be first downloaded using a different name from the current runtime code
file, and then the new file set as the startup file.
Saving or Restoring Configuration Settings
Configuration settings can be uploaded and downloaded to and from an FTP/SFTP/TFTP server.
The configuration file can be later downloaded to restore switch settings.
The configuration file can be downloaded under a new file name and then set as the startup file, or
the current startup configuration file can be specified as the destination file to directly replace it.
Note that the file “Factory_Default_Config.cfg” can be copied to the FTP/SFTP/TFTP server, but
cannot be used as the destination on the switch.
General Commands
boot system
This command specifies the file or image used to start up the system.
Syntax
boot system {boot-rom | config | opcode}: filename
boot-rom* - Boot ROM.
config* - Configuration file.
opcode* - Run-time operation code.
filename - Name of configuration file or code image.
* The colon (:) is required.
TABLE 15
Flash/File Commands
Command
Function
Mode
General Commands
Specifies the file or image used to start up the system
GC
Copies a code image or a switch configuration to or from flash memory
or an FTP/SFTP/TFTP server
PE
Deletes a file or code image
PE
Displays a list of files in flash memory
PE
Displays the files booted
PE
Automatic Code Upgrade Commands
Automatically upgrades the current image when a new version is
detected on the indicated server
GC
Specifies an FTP/TFTP server and directory in which the new opcode is
stored
GC
Reloads the switch automatically after the opcode upgrade is
completed
GC
Shows the opcode upgrade configuration settings.
PE