Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 117)

Brocade 6910 Ethernet Access Switch Configuration Guide 61
53-1002651-02
5
System Status
username admin access-level 15
username admin password 7 21232f297a57a5a743894a0e4a801fc3
username guest access-level 0
username guest password 7 084e0343a0486ff05530df6c705c8bb4
enable password level 15 7 1b3231655cebb7a1f783eddf27d254ca
!
vlan database
VLAN 1 name DefaultVlan media ethernet state active
!
spanning-tree mst configuration
!
interface ethernet 1/1
ip igmp max-groups 1023
ip igmp max-groups action deny
.
.
.
!
interface vlan 1
ip address dhcp
!
interface craft
!
line console
!
line vty
!
end
!
Console#
Related Commands
“show startup-config” on page 61
show startup-config
This command displays the configuration file stored in non-volatile memory that is used to start up
the system.
Command Mode
Privileged Exec
Command Usage
• Use this command in conjunction with the show running-config command to compare the
information in running memory to the information stored in non-volatile memory.
• This command displays settings for key command modes. Each mode group is separated by “!”
symbols, and includes the configuration mode command, and corresponding commands. This
command displays the following information:
• MAC address for the switch
• SNMP community strings
• SNMP trap authentication
• Users (names and access levels)
• VLAN database (VLAN ID, name and state)
• Multiple spanning tree instances (name and interfaces)