Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 162

106
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
6
SNMP Commands
Displays the configured notification logs
PE
ATC Trap Commands
snmp-server enable traps
ethernet cfm delay-measure
threshold
Enables SNMP trap generation for frame delay measurements
above a configured threshold
GC
snmp-server enable port-traps
atc broadcast-alarm-clear
Sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered
IC (Port)
snmp-server enable port-traps
atc broadcast-alarm-fire
Sends a trap when broadcast traffic exceeds the upper threshold
for automatic storm control
IC (Port)
snmp-server enable port-traps
atc broadcast-control-apply
Sends a trap when broadcast traffic exceeds the upper threshold
for automatic storm control and the apply timer expires
IC (Port)
snmp-server enable port-traps
atc broadcast-control-release
Sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered and
the release timer expires
IC (Port)
snmp-server enable port-traps
atc multicast-alarm-clear
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been triggered
IC (Port)
snmp-server enable port-traps
atc multicast-alarm-fire
Sends a trap when multicast traffic exceeds the upper threshold
for automatic storm control
IC (Port)
snmp-server enable port-traps
atc multicast-control-apply
Sends a trap when multicast traffic exceeds the upper threshold
for automatic storm control and the apply timer expires
IC (Port)
snmp-server enable port-traps
atc multicast-control-release
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been triggered and
the release timer expires
IC (Port)
Transceiver Power Threshold Trap Commands
Sends a trap when the transceiver current falls outside the
specified thresholds
IC (Port)
transceiver-threshold rx-power
Sends a trap when the power level of the received signal falls
outside the specified thresholds
IC (Port)
transceiver-threshold
temperature
Sends a trap when the transceiver temperature falls outside the
specified thresholds
IC (Port)
transceiver-threshold tx-power
Sends a trap when the power level of the transmitted signal power
outside the specified thresholds
IC (Port)
Sends a trap when the transceiver voltage falls outside the
specified thresholds
IC (Port)
Additional Trap Commands
Sets the rising and falling threshold for the memory utilization
alarm
GC
Sets the rising and falling threshold for the CPU utilization alarm
GC
Shows memory utilization parameters
PE
Shows CPU utilization parameters
PE
TABLE 26
SNMP Commands (Continued)
Command
Function
Mode