Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 687)

Brocade 6910 Ethernet Access Switch Configuration Guide 631
53-1002651-02
30
IP Routing Commands
Console#
show ip route database
This command displays entries in the Routing Information Base (RIB).
Command Mode
Privileged Exec
Command Usage
The RIB contains all directly attached networks, and any additionally configured routes such as
static routes. The RIB contains the set of all available routes from which optimal entries are
selected for use by the Forwarding Information Base (see Command Usage under the
show ip route
command).
Example
Console#show ip route database
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
> - selected route, * - FIB route, p - stale info
S *> 10.1.1.0/24 [1/0] via 192.168.0.254, VLAN1
> [1/0] via 192.168.1.254, VLAN2
C *> 192.168.0.0/24 is directly connected, VLAN1
C *> 192.168.1.0/24 is directly connected, VLAN2
Console#