Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1084)

1028 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
43
Connectivity Fault Management
• AIS Transmit Level – The maintenance level at which AIS information will be sent for the
specified MEP.
• Suppress Alarm – Shows if the specified MEP is configured to suppress sending frames
containing AIS information following the detection of defect conditions.
• Suppressing Alarms – Shows if the specified MEP is currently suppressing sending frames
containing AIS information following the detection of defect conditions.
• Delay Measure – Configuration settings for periodic delay-measure messages.
• Status – Shows if transmission of delay-measure messages is enabled or not.
• Method – Shows if one-way, two-way or no delay-measure messages are configured.
• Destination – The destination MEP for transmitted delay-measure messages.
• Loss Measure – Configuration settings for periodic loss-measure messages.
• Dual-ended Status – Shows if dual-ended loss-measure messages are enabled or not.
• Dual-ended Destination – Destination MEP for dual-ended loss-measure messages.
• Single-ended Status – Shows if single-ended loss-measure messages are enabled or not.
• Single-ended Destination – Destination MEP for single-ended loss-measure messages.
Interface
To show detailed information for the MEPs configured on this device:
1. Click Administration, CFM.
2. Select Show Information from the Step list.
3. Select Show Local MEP Details from the Action list.
4. Select an entry from MD Index and MA Index.
5. Select a MEP ID.