Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 839)

Brocade 6910 Ethernet Access Switch Configuration Guide 783
53-1002651-02
36
Clearing the Dynamic Address Table
Clearing the Dynamic Address Table
Use the MAC Address > Dynamic (Clear Dynamic MAC) page to remove any learned entries from the
forwarding database.
CLI References
• “clear mac-address-table dynamic” on page 325
Parameters
These parameters are displayed:
• Clear by – All entries can be cleared; or you can clear the entries for a specific MAC address, all
the entries in a VLAN, or all the entries associated with a port or trunk.
Interface
To clear the entries in the dynamic address table:
1. Click MAC Address, Dynamic.
2. Select Clear Dynamic MAC from the Action list.
3. Select the method by which to clear the entries (i.e., All, MAC Address, VLAN, or Interface).
4. Enter information in the additional fields required for clearing entries by MAC Address, VLAN, or
Interface.
5. Click Clear.
FIGURE 115 Clearing Entries in the Dynamic MAC Address Table
Configuring MAC Address Mirroring
Use the MAC Address > Mirror (Add) page to mirror traffic matching a specified source address
from any port on the switch to a target port for real-time analysis. You can then attach a logic
analyzer or RMON probe to the target port and study the traffic crossing the source port in a
completely unobtrusive manner.
CLI References
• “Local Port Mirroring Commands” on page 297
Command Usage
• When mirroring traffic from a MAC address, ingress traffic with the specified source address
entering any port in the switch, other than the target port, will be mirrored to the destination
port.