Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 485)

Brocade 6910 Ethernet Access Switch Configuration Guide 429
53-1002651-02
22
Quality of Service Commands
Example
This example creates a class map call “rd-class,” and sets it to match packets marked for DSCP
service value 3:
Console(config)#class-map rd-class match-any
Console(config-cmap)#match ip dscp 3
Console(config-cmap)#
Related Commands
“show class-map” on page 441
description
This command specifies the description of a class map or policy map.
Syntax
description string
string - Description of the class map or policy map. (Range: 1-64 characters)
Command Mode
Class Map Configuration
Policy Map Configuration
Example
Console(config)#class-map rd-class#1
Console(config-cmap)#description matches packets marked for DSCP service value 3
Console(config-cmap)#
match
This command defines the criteria used to classify traffic. Use the no form to delete the matching
criteria.
Syntax
[no] match {access-list acl-name | cos cos | ip dscp dscp |
ip precedence ip-precedence | source-port interface| vlan vlan}
acl-name - Name of the access control list. Any type of ACL can be specified, including
standard or extended IPv4/IPv6 ACLs and MAC ACLs. (Range: 1-16 characters)
cos - A Class of Service value. (Range: 0-7)
dscp - A Differentiated Service Code Point value. (Range: 0-63)
ip-precedence - An IP Precedence value. (Range: 0-7)
interface
unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
vlan - A VLAN. (Range:1-4093)