Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 331)

Brocade 6910 Ethernet Access Switch Configuration Guide 275
53-1002651-02
12
Interface Commands
Command Usage
If no interface is specified, information on all interfaces is displayed. For a description of the items
displayed by this command, see
“Displaying Connection Status” on page 704.
Example
Console#show interfaces status ethernet 1/1
Information of Eth 1/1
Basic Information:
Port Type : 1000BASE-T
MAC Address : 00-E0-0C-00-00-FE
Configuration:
Name :
Port Admin : Up
Speed-duplex : Auto
Capabilities : 10half, 10full, 100half, 100full
Broadcast Storm : Enabled
Broadcast Storm Limit : 500 packets/second
Multicast Storm : Disabled
Multicast Storm Limit : 64 Kbits/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 64 Kbits/second
Flow Control : Disabled
VLAN Trunking : Disabled
LACP : Disabled
Port Security : Disabled
Media Type : Copper forced
Current Status:
Link Status : Up
Port Operation Status : Up
Operation Speed-duplex : 100full
Flow Control Type : None
Max Frame Size : 10240 bytes (10240 bytes for tagged frames)
Console#
show interfaces switchport
This command displays the administrative and operational status of the specified interfaces.
Syntax
show interfaces switchport [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
Default Setting
Shows all interfaces.
Command Mode
Normal Exec, Privileged Exec