Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 141)

Brocade 6910 Ethernet Access Switch Configuration Guide 85
53-1002651-02
5
Event Logging
Default Setting
Flash: errors (level 3 - 0)
RAM: debugging (level 7 - 0)
Command Mode
Global Configuration
Command Usage
The message level specified for flash memory must be a higher priority (i.e., numerically lower)
than that specified for RAM.
Example
Console(config)#logging history ram 0
Console(config)#
logging host
This command adds a syslog server host IP address that will receive logging messages. Use the no
form to remove a syslog server host.
Syntax
[no] logging host host-ip-address
host-ip-address - The IP address of a syslog server.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use this command more than once to build up a list of host IP addresses.
• The maximum number of host IP addresses allowed is five.
TABLE 19 Logging Levels
Level Severity Name Description
7 debugging Debugging messages
6 informational Informational messages only
5 notifications Normal but significant condition, such as cold start
4 warnings Warning conditions (e.g., return false, unexpected return)
3 errors Error conditions (e.g., invalid input, default used)
2 critical Critical conditions (e.g., memory allocation, or free memory error -
resource exhausted)
1 alerts Immediate action needed
0 emergencies System unusable