Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1168)

1112 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
47
Filtering and Throttling IGMP Groups
To add a range of multicast groups to an IGMP filter profile:
1. Click Multicast, IGMP Snooping, Filter.
2. Select Configure Profile from the Step list.
3. Select Add Multicast Group Range from the Action list.
4. Select the profile to configure, and add a multicast group address or range of addresses.
5. Click Apply.
FIGURE 386 Adding Multicast Groups to an IGMP Filtering Profile
To show the multicast groups configured for an IGMP filter profile:
1. Click Multicast, IGMP Snooping, Filter.
2. Select Configure Profile from the Step list.
3. Select Show Multicast Group Range from the Action list.
4. Select the profile for which to display this information.
FIGURE 387 Showing the Groups Assigned to an IGMP Filtering Profile
Configuring IGMP Filtering and Throttling for Interfaces
Use the Multicast > IGMP Snooping > Filter (Configure Interface) page to assign and IGMP filter
profile to interfaces on the switch, or to throttle multicast traffic by limiting the maximum number of
multicast groups an interface can join at the same time.
CLI References
• “IGMP Filtering and Throttling” on page 464