Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 360)

304 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
14
RSPAN Mirroring Commands
Example
The following example enables RSPAN on VLAN 2, specifies this device as an RSPAN destination
switch, and the uplink interface as port 3:
Console(config)#rspan session 1 remote vlan 2 destination uplink ethernet 1/3
Console(config)#
no rspan session
Use this command to delete a configured RSPAN session.
Syntax
no rspan session session-id
session-id – A number identifying this RSPAN session. (Range: 1)
Only two mirror sessions are allowed, including both local and remote mirroring. If local
mirroring is enabled with the
port monitor command, then there is only one session
available for RSPAN.
Command Mode
Global Configuration
Command Usage
The no rspan session command must be used to disable an RSPAN VLAN before it can be deleted
from the VLAN database (see the
vlan command).
Example
Console(config)#no rspan session 1
Console(config)#
show rspan
Use this command to displays the configuration settings for an RSPAN session.
Syntax
show rspan session [session-id]
session-id – A number identifying this RSPAN session. (Range: 1)
Only two mirror sessions are allowed, including both local and remote mirroring. If local
mirroring is enabled with the
port monitor command, then there is only one session
available for RSPAN.
Command Mode
Privileged Exec
Example
Console#show rspan session
RSPAN Session ID : 1
Source Ports (mirrored ports) : None
RX Only : None
TX Only : None
BOTH : None
Destination Port (monitor port) : Eth 1/2