Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 392)

336 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
18
Spanning Tree Commands
Example
Console(config)#spanning-tree mst configuration
Console(config-mstp)#
Related Commands
“mst vlan” on page 338
“mst priority” on page 337
“name” on page 339
“revision” on page 339
“max-hops” on page 337
spanning-tree system-bpdu-flooding
This command configures the system to flood BPDUs to all other ports on the switch or just to all
other ports in the same VLAN when spanning tree is disabled globally on the switch or disabled on
a specific port. Use the no form to restore the default.
Syntax
spanning-tree system-bpdu-flooding {to-all | to-vlan}
no spanning-tree system-bpdu-flooding
to-all - Floods BPDUs to all other ports on the switch.
to-vlan - Floods BPDUs to all other ports within the receiving port’s native VLAN (i.e., as
determined by port’s PVID).
Default Setting
Floods to all other ports in the same VLAN.
Command Mode
Global Configuration
Command Usage
The spanning-tree system-bpdu-flooding command has no effect if BPDU flooding is disabled on a
port (see the
spanning-tree port-bpdu-flooding command).
Example
Console(config)#spanning-tree system-bpdu-flooding
Console(config)#
spanning-tree transmission-limit
This command configures the minimum interval between the transmission of consecutive
RSTP/MSTP BPDUs. Use the no form to restore the default.
Syntax
spanning-tree transmission-limit count
no spanning-tree transmission-limit
count - The transmission limit in seconds. (Range: 1-10)