beautypg.com

Network-access port-mac-filter, Mac- authentication intrusion-action – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 258

background image

202

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002651-02

10

Network Access (MAC Address Authentication)

network-access port-mac-filter

Use this command to enable the specified MAC address filter. Use the no form of this command to
disable the specified MAC address filter.

Syntax

network-access port-mac-filter filter-id

no network-access port-mac-filter

filter-id - Specifies a MAC address filter table. (Range: 1-64)

Default Setting
None

Command Mode
Interface Configuration

Command Mode

Entries in the MAC address filter table can be configured with the

network-access mac-filter

command.

Only one filter table can be assigned to a port.

Example

Console(config)#interface ethernet 1/1

Console(config-if)#network-access port-mac-filter 1

Console(config-if)#

mac- authentication intrusion-action

Use this command to configure the port response to a host MAC authentication failure. Use the no
form of this command to restore the default.

Syntax

mac-authentication intrusion-action {block traffic | pass traffic}

no mac-authentication intrusion-action

Default Setting
Block Traffic

Command Mode
Interface Con figuration

Example

Console(config-if)#mac-authentication intrusion-action block-traffic

Console(config-if)#