beautypg.com

General commands, Dot1x default – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 229

background image

Brocade 6910 Ethernet Access Switch Configuration Guide

173

53-1002651-02

9

802.1X Port Authentication

General Commands

dot1x default

This command sets all configurable dot1x global and port settings to their default values.

Command Mode
Global Configuration

Authenticator Commands

dot1x intrusion-action

Sets the port response to intrusion when authentication fails

IC

dot1x max-reauth-req

Sets the maximum number of times that the switch sends an
EAP-request/identity frame to the client before restarting the
authentication process

IC

dot1x max-req

Sets the maximum number of times that the switch retransmits an
EAP request/identity packet to the client before it times out the
authentication session

IC

dot1x operation-mode

Allows single or multiple hosts on an dot1x port

IC

dot1x port-control

Sets dot1x mode for a port interface

IC

dot1x re-authentication

Enables re-authentication for all ports

IC

dot1x timeout quiet-period

Sets the time that a switch port waits after the Max Request Count
has been exceeded before attempting to acquire a new client

IC

dot1x timeout re-authperiod

Sets the time period after which a connected client must be
re-authenticated

IC

dot1x timeout supp-timeout

Sets the interval for a supplicant to respond

IC

dot1x timeout tx-period

Sets the time period during an authentication session that the
switch waits before re-transmitting an EAP packet

IC

dot1x re-authenticate

Forces re-authentication on specific ports

PE

Supplicant Commands

dot1x identity profile

Configures dot1x supplicant user name and password

GC

dot1x max-start

Sets the maximum number of times that a port supplicant will send
an EAP start frame to the client

IC

dot1x pae supplicant

Enables dot1x supplicant mode on an interface

IC

dot1x timeout auth-period

Sets the time that a supplicant port waits for a response from the
authenticator

IC

dot1x timeout held-period

Sets the time a port waits after the maximum start count has been
exceeded before attempting to find another authenticator

IC

dot1x timeout start-period

Sets the time that a supplicant port waits before resending an
EAPOL start frame to the authenticator

IC

Information Display Commands

show dot1x

Shows all dot1x related information

PE

TABLE 45

802.1X Port Authentication Commands (Continued)

Command

Function

Mode