Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 106)

50 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
5
Banner Information
Electrical circuit: : ec-177743209-xb
Number of LP:12
Position of the equipment in the MUX:1/23
IP LAN:192.168.1.1
Note: This is a random note about this managed switch and can contain
miscellaneous information.
Console(config)#
banner configure company
This command is used to configure company information displayed in the banner. Use the no form
to remove the company name from the banner display.
Syntax
banner configure company name
no banner configure company
name - The name of the company. (Maximum length: 32 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
Input strings cannot contain spaces. The banner configure company command interprets spaces
as data input boundaries. The use of underscores ( _ ) or other unobtrusive non-letter characters is
suggested for situations where white space is necessary for clarity.
Example
Console(config)#banner configure company Big-Ben
Console(config)#
banner configure dc-power-info
This command is use to configure DC power information displayed in the banner. Use the no form
to restore the default setting.
Syntax
banner configure dc-power-info floor floor-id row row-id rack rack-id electrical-circuit ec-id
no banner configure dc-power-info [floor | row | rack | electrical-circuit]
floor-id - The floor number.
row-id - The row number.
rack-id - The rack number.
ec-id - The electrical circuit ID.
Maximum length of each parameter: 32 characters