Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 208)

152 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
9
AAA
aaa accounting dot1x
This command enables the accounting of requested 802.1X services for network access. Use the
no form to disable the accounting service.
Syntax
aaa accounting dot1x {default | method-name}
start-stop group {radius | tacacs+ |server-group}
no aaa accounting dot1x {default | method-name}
default - Specifies the default accounting method for service requests.
method-name - Specifies an accounting method for service requests. (Range: 1-64
characters)
start-stop - Records accounting from starting point and stopping point.
group - Specifies the server group to use.
radius - Specifies all RADIUS hosts configure with the radius-server host command.
tacacs+ - Specifies all TACACS+ hosts configure with the tacacs-server host command.
server-group - Specifies the name of a server group configured with the aaa group
server command. (Range: 1-64 characters)
Default Setting
Accounting is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
Note that the default and method-name fields are only used to describe the accounting method(s)
configured on the specified RADIUS or TACACS+ servers, and do not actually send any information
to the servers about the methods to use.
Example
Console(config)#aaa accounting dot1x default start-stop group radius
Console(config)#
accounting exec Applies an accounting method to local console, Telnet or SSH
connections Line
authorization exec Applies an authorization method to local console, Telnet or SSH
connections Line
show accounting Displays all accounting information PE
TABLE 39 AAA Commands (Continued)
Command Function Mode