beautypg.com

Specifying trap managers, Figure 266 confi, Figure 267 s – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 1021

background image

Brocade 6910 Ethernet Access Switch Configuration Guide

965

53-1002651-02

43

Simple Network Management Protocol

FIGURE 266

Configuring Remote SNMPv3 Users

To show remote SNMPv3 users:

1. Click Administration, SNMP.

2. Select Configure User from the Step list.

3. Select Show SNMPv3 Remote User from the Action list.

FIGURE 267

Showing Remote SNMPv3 Users

Specifying Trap Managers

Use the Administration > SNMP (Configure Trap) page to specify the host devices to be sent traps
and the types of traps to send. Traps indicating status changes are issued by the switch to the
specified trap managers. You must specify trap managers so that key events are reported by this
switch to your management station (using network management software). You can specify up to
five management stations that will receive authentication failure messages and other trap
messages from the switch.

CLI References

“snmp-server host”

on page 111