Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 239)

Brocade 6910 Ethernet Access Switch Configuration Guide 183
53-1002651-02
9
802.1X Port Authentication
Command Mode
Interface Configuration
Command Usage
This command sets the time that the supplicant waits for a response from the authenticator for
packets other than EAPOL-Start.
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout auth-period 60
Console(config-if)#
dot1x timeout held-period
This command sets the time that a supplicant port waits before resending its credentials to find a
new an authenticator. Use the no form to reset the default.
Syntax
dot1x timeout held-period seconds
no dot1x timeout held-period
seconds - The number of seconds. (Range: 1-65535)
Default
60 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout held-period 120
Console(config-if)#
dot1x timeout start-period
This command sets the time that a supplicant port waits before resending an EAPOL start frame to
the authenticator. Use the no form to restore the default setting.
Syntax
dot1x timeout start-period seconds
no dot1x timeout start-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration