Ipv6 host – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 639
Brocade 6910 Ethernet Access Switch Configuration Guide
583
53-1002651-02
27
Domain Name Service Commands
Command Usage
The listed name servers are queried in the specified sequence until a response is received, or the
end of the list is reached with no response.
Example
This example adds two domain-name servers to the list and then displays the list.
Console(config)#ip name-server 192.168.1.55 10.1.0.55
Console(config)#end
Console#show dns
Domain Lookup Status:
DNS disabled
Default Domain Name:
sample.com
Domain Name List:
sample.com.jp
sample.com.uk
Name Server List:
192.168.1.55
10.1.0.55
Console#
Related Commands
ipv6 host
This command creates a static entry in the DNS table that maps a host name to an IPv6 address.
Use the no form to remove an entry.
Syntax
[no] ipv6 host name ipv6-address
name - Name of an IPv6 host. (Range: 1-100 characters)
ipv6-address - Corresponding IPv6 address. This address must be entered according to
RFC 2373 “IPv6 Addressing Architecture,” using 8 colon-separated 16-bit hexadecimal
values. One double colon may be used in the address to indicate the appropriate number
of zeros required to fill the undefined fields.
Default Setting
No static entries
Command Mode
Global Configuration