Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 962)

906 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
42
ARP Inspection
Parameters
These parameters are displayed:
Interface
To display statistics for ARP Inspection:
1. Click Security, ARP Inspection.
2. Select Show Information from the Step list.
3. Select Show Statistics from the Action list.
FIGURE 221 Displaying Statistics for ARP Inspection
TABLE 169 ARP Inspection Statistics
Parameter Description
Received ARP packets before ARP
inspection rate limit Count of ARP packets received but not exceeding the ARP Inspection rate
limit.
Dropped ARP packets in the process
of ARP inspection rate limit Count of ARP packets exceeding (and dropped by) ARP rate limiting.
ARP packets dropped by additional
validation (IP) Count of ARP packets that failed the IP address test.
ARP packets dropped by additional
validation (Dst-MAC) Count of packets that failed the destination MAC address test.
Total ARP packets processed by ARP
inspection Count of all ARP packets processed by the ARP Inspection engine.
ARP packets dropped by additional
validation (Src-MAC) Count of packets that failed the source MAC address test.
ARP packets dropped by ARP ACLs Count of ARP packets that failed validation against ARP ACL rules.
ARP packets dropped by DHCP
snooping Count of packets that failed validation against the DHCP Snooping
Binding database.