Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 556)

500 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
24
LLDP Commands
lldp
This command enables LLDP globally on the switch. Use the no form to disable LLDP.
Syntax
[no] lldp
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#lldp
Console(config)#
lldp holdtime-multiplier
This command configures the time-to-live (TTL) value sent in LLDP advertisements. Use the no form
to restore the default setting.
Syntax
lldp holdtime-multiplier value
no lldp holdtime-multiplier
value - Calculates the TTL in seconds based on the following rule:
minimum ((Transmission Interval * Holdtime Multiplier), or 65536)
(Range: 2 - 10)
Default Setting
Holdtime multiplier: 4
TTL: 4*30 = 120 seconds
lldp dot3-tlv mac-phy Configures an LLDP-enabled port to advertise its MAC and physical layer
specifications IC
lldp dot3-tlv max-frame Configures an LLDP-enabled port to advertise its maximum frame size IC
lldp notification Enables the transmission of SNMP trap notifications about LLDP changes IC
show lldp config Shows LLDP configuration settings for all ports PE
show lldp info
local-device Shows LLDP global and interface-specific configuration settings for this
device PE
show lldp info
remote-device Shows LLDP global and interface-specific configuration settings for
remote devices PE
show lldp info statistics Shows statistical counters for all LLDP-enabled interfaces PE
* Vendor-specific options may or may not be advertised by neighboring devices.
TABLE 123 LLDP Commands (Continued)
Command Function Mode