beautypg.com

Show snmp – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 165

background image

Brocade 6910 Ethernet Access Switch Configuration Guide

109

53-1002651-02

6

SNMP Commands

show snmp

This command can be used to check the status of SNMP communications.

Default Setting
None

Command Mode
Normal Exec, Privileged Exec

Command Usage
This command provides information on the community access strings, counter information for
SNMP input and output protocol data units, and whether or not SNMP logging has been enabled
with the snmp-server enable traps command.

Example

Console#show snmp

SNMP Agent : Enabled

SNMP Traps :

Authentication : Enabled

Link-up-down : Enabled

SNMP Communities :

1. public, and the access level is read-only

2. private, and the access level is read/write

0 SNMP packets input

0 Bad SNMP version errors

0 Unknown community name

0 Illegal operation for community name supplied

0 Encoding errors

0 Number of requested variables

0 Number of altered variables

0 Get-request PDUs

0 Get-next PDUs

0 Set-request PDUs

0 SNMP packets output

0 Too big errors

0 No such name errors

0 Bad values errors

0 General errors

0 Response PDUs

0 Trap PDUs

SNMP Logging: Disabled

Console#