Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 373)

Brocade 6910 Ethernet Access Switch Configuration Guide 317
53-1002651-02
16
Automatic Traffic Control Commands
SNMP Trap Commands
snmp-server enable port-traps atc broadcast-alarm-clear
This command sends a trap when broadcast traffic falls beneath the lower threshold after a storm
control response has been triggered. Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc broadcast-alarm-clear
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-clear
Console(config-if)#
Related Commands
“auto-traffic-control action” on page 313
“auto-traffic-control alarm-clear-threshold” on page 314
snmp-server enable port-traps atc broadcast-alarm-fire
This command sends a trap when broadcast traffic exceeds the upper threshold for automatic
storm control. Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc broadcast-alarm-fire
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-fire
Console(config-if)#
Related Commands
“auto-traffic-control alarm-fire-threshold” on page 315