Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 927)

Brocade 6910 Ethernet Access Switch Configuration Guide 871
53-1002651-02
42
Network Access (MAC Address Authentication)
To show the MAC address filter table for MAC authentication:
1. Click Security, Network Access.
2. Select Configure MAC Filter from the Step list.
3. Select Show from the Action list.
FIGURE 192 Showing the MAC Address Filter Table for Network Access
Displaying Secure MAC Address Information
Use the Security > Network Access (Show Information) page to display the authenticated MAC
addresses stored in the secure MAC address table. Information on the secure MAC entries can be
displayed and selected entries can be removed from the table.
CLI References
• “Network Access (MAC Address Authentication)” on page 193
Parameters
These parameters are displayed:
• Query By – Specifies parameters to use in the MAC address query.
• Sort Key – Sorts the information displayed based on MAC address, port interface, or
attribute.
• MAC Address – Specifies a specific MAC address.
• Interface – Specifies a port interface.
• Attribute – Displays static or dynamic addresses.
• Authenticated MAC Address List
• MAC Address – The authenticated MAC address.
• Interface – The port interface associated with a secure MAC address.
• RADIUS Server – The IP address of the RADIUS server that authenticated the MAC
address.
• Time – The time when the MAC address was last authenticated.
• Attribute – Indicates a static or dynamic address.
Interface
To display the authenticated MAC addresses stored in the secure MAC address table:
1. Click Security, Network Access.
2. Select Show Information from the Step list.