Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 242)

186 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
9
Management IP Filter
Port Type Operation Mode Control Mode Authorized
-------- ------------- -------------- ------------------ ----------
Eth 1/ 1 Disabled Single-Host Force-Authorized Yes
Eth 1/ 2 Disabled Single-Host Force-Authorized Yes
.
.
.
Eth 1/11 Disabled Single-Host Force-Authorized Yes
Eth 1/12 Enabled Single-Host Auto Yes
802.1X Port Details
802.1X Authenticator is enabled on port 1/1
802.1X Supplicant is disabled on port 1/1
.
.
.
802.1X Authenticator is enabled on port 10
Reauthentication : Enabled
Reauth Period : 3600 seconds
Quiet Period : 60 seconds
TX Period : 30 seconds
Supplicant Timeout : 30 seconds
Server Timeout : 10 seconds
Reauth Max Retries : 2
Max Request : 2
Operation Mode : Multi-host
Port Control : Auto
Intrusion Action : Block traffic
Supplicant : 00-e0-29-94-34-65
Authenticator PAE State Machine
State : Authenticated
Reauth Count : 0
Current Identifier : 3
Backend State Machine
State : Idle
Request Count : 0
Identifier(Server) : 2
Reauthentication State Machine
State : Initialize
Console#
Management IP Filter
This section describes commands used to configure IP management access to the switch.
TABLE 46 Management IP Filter Commands
Command Function Mode
management Configures IP addresses that are allowed management access GC
show management Displays the switch to be monitored or configured from a browser PE