Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 564)

508 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
24
LLDP Commands
lldp dot1-tlv vlan-name
This command configures an LLDP-enabled port to advertise its VLAN name. Use the no form to
disable this feature.
Syntax
[no] lldp dot1-tlv vlan-name
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the name of all VLANs to which this interface has been assigned. See
“switchport allowed vlan” on page 379 and “protocol-vlan protocol-group (Configuring Interfaces)”
on page 401.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv vlan-name
Console(config-if)#
lldp dot3-tlv link-agg
This command configures an LLDP-enabled port to advertise link aggregation capabilities. Use the
no form to disable this feature.
Syntax
[no] lldp dot3-tlv link-agg
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises link aggregation capabilities, aggregation status of the link, and the 802.3
aggregated port identifier if this interface is currently a link aggregation member.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv link-agg
Console(config-if)#