Mvr associated-profile, Mvr mvr associated-profile – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 527

Brocade 6910 Ethernet Access Switch Configuration Guide
471
53-1002651-02
23
MVR for IPv4
mvr
This command enables Multicast VLAN Registration (MVR) globally on the switch. Use the no form
of this command to globally disable MVR.
Syntax
[no] mvr
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages. If MVR must be
configured for an IGMP version 1 host, the multicast groups must be statically assigned using the
command.
Example
The following example enables MVR globally.
Console(config)#mvr
Console(config)#
mvr associated-profile
This command binds the MVR group addresses specified in a profile to an MVR domain. Use the no
form of this command to remove the binding.
Syntax
[no] mvr domain domain-id associated-profile profile-name
domain-id - An independent multicast domain. (Range: 1-5)
profile-name - The name of a profile containing one or more MVR group addresses.
(Range: 1-21 characters)
Default Setting
Disabled
Command Mode
Global Configuration
Shows information about the current number of entries in the
forwarding database, or detailed information about a specific
multicast address
PE
Shows all configured MVR profiles
PE
Shows MVR protocol statistics for the specified interface
PE
TABLE 110
Multicast VLAN Registration for IPv4 Commands (Continued)
Command
Function
Mode