Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 145)

Brocade 6910 Ethernet Access Switch Configuration Guide 89
53-1002651-02
5
SMTP Alerts
Syslog logging: Enabled
History logging in RAM: level debugging
Console#
The following example displays settings for the trap function.
Console#show logging trap
Remote Log Status : Disabled
Remote Log Facility Type : Local use 7
Remote Log Level Type : Debugging messages
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Console#
Related Commands
“show logging sendmail” on page 92
SMTP Alerts
These commands configure SMTP event handling, and forwarding of alert messages to the
specified SMTP servers and email recipients.
TABLE 20 show logging flash/ram - display description
Field Description
Syslog logging Shows if system logging has been enabled via the logging on command.
History logging in FLASH The message level(s) reported based on the logging history command.
History logging in RAM The message level(s) reported based on the logging history command.
TABLE 21 show logging trap - display description
Field Description
Syslog logging Shows if system logging has been enabled via the logging on command.
REMOTELOG status Shows if remote logging has been enabled via the logging trap command.
REMOTELOG facility type The facility type for remote logging of syslog messages as specified in the logging
facility command.
REMOTELOG level type The severity threshold for syslog messages sent to a remote server as specified in
the
logging trap command.
REMOTELOG
server IP address The address of syslog servers as specified in the logging host command.
TABLE 22 Event Logging Commands
Command Function Mode
logging sendmail Enables SMTP event handling GC
logging sendmail host SMTP servers to receive alert messages GC
logging sendmail level Severity threshold used to trigger alert messages GC