Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1180)

1124 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
47
Multicast VLAN Registration for IPv4
Interface
To display the interfaces assigned to the MVR receiver groups:
1. Click Multicast, MVR.
2. Select Show Member from the Step list.
3. Select an MVR domain.
FIGURE 399 Displaying MVR Receiver Groups
Displaying MVR Statistics
Use the Multicast > MVR > Show Statistics pages to display MVR protocol-related statistics for the
specified interface.
CLI References
• “show mvr statistics” on page 483
Parameters
These parameters are displayed:
• Domain ID – An independent multicast domain. (Range: 1-5)
• VLAN – VLAN identifier. (Range: 1-4093)
• Port – Port identifier. (Range: 1-12)
• Trunk – Trunk identifier. (Range: 1-12)
Query Statistics
• Querier IP Address – The IP address of the querier on this interface.
• Querier Expire Time – The time after which this querier is assumed to have expired.
• General Query Received – The number of general queries received on this interface.
• General Query Sent – The number of general queries sent from this interface.
• Specific Query Received – The number of specific queries received on this interface.
• Specific Query Sent – The number of specific queries sent from this interface.
• Number of Reports Sent – The number of reports sent from this interface.
• Number of Leaves Sent – The number of leaves sent from this interface.
VLAN, Port, and Trunk Statistics
Input Statistics
• Report – The number of IGMP membership reports received on this interface.