beautypg.com

Displaying remote meps, Figure 319 s – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 1086

background image

1030

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002651-02

43

Connectivity Fault Management

MA Name – Maintenance association name.

Primary VLAN – Service VLAN ID.

Interface – Physical interface of this entry (either a port or trunk).

Interface
To show information for the MIPs discovered by the CFM protocol:

1. Click Administration, CFM.

2. Select Show Information from the Step list.

3. Select Show Local MIP from the Action list.

FIGURE 319

Showing Information on Local MIPs

Displaying Remote MEPs

Use the Administration > CFM > Show Information (Show Remote MEP) page to show MEPs located
on other devices which have been discovered through continuity check messages, or statically
configured in the MEP database and verified through cross-check messages.

CLI References

“show ethernet cfm maintenance-points remote detail”

on page 535

“clear ethernet cfm maintenance-points remote”

on page 540

Parameters
These parameters are displayed:

MEP ID – Maintenance end point identifier.

MA Name – Maintenance association name.

Level – Authorized maintenance level for this domain.

Primary VLAN – Service VLAN ID.

MEP Up – Indicates whether or not this MEP is functioning normally.

Remote MAC Address – MAC address of the remote maintenance point. (If a CCM for the
specified remote MEP has never been received or the remote MEP record times out, the
address will be set to the initial value of all Fs.)