Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 308)

252 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
11
ACL Information
Example
Console#show access-list arp
ARP access-list factory:
permit response ip any 192.168.0.0 255.255.0.0 mac any any
Console#
Related Commands
“permit, deny (ARP ACL)” on page 250
ACL Information
This section describes commands used to display ACL information.
clear access-list hardware counters
This command clears the hit counter for the rules in all ACLs, or for the rules in a specified ACL.
Syntax
clear access-list hardware counters [acl-name]
acl-name – Name of the ACL. (Maximum length: 16 characters)
Command Mode
Privileged Exec
Example
Console#clear access-list hardware counters
Console#
show access-group
This command shows the port assignments of ACLs.
Command Mode
Privileged Executive
Example
Console#show access-group
Interface ethernet 1/2
IP access-list david
MAC access-list jerry
Console#
TABLE 62 ACL Information Commands
Command Function Mode
clear access-list hardware
counters Clears hit counter for rules in all ACLs, or in a specified ACL. PE
show access-group Shows the ACLs assigned to each port PE
show access-list Show all ACLs and associated rules PE