Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 513)

Brocade 6910 Ethernet Access Switch Configuration Guide 457
53-1002651-02
23
IGMP Snooping
Example
Console(config)#ip igmp snooping vlan 1 query-interval 150
Console(config)#
ip igmp snooping vlan query-resp-intvl
This command configures the maximum time the system waits for a response to general queries.
Use the no form to restore the default.
Syntax
ip igmp snooping vlan vlan-id query-resp-intvl interval
no ip igmp snooping vlan vlan-id query-resp-intvl
vlan-id - VLAN ID (Range: 1-4093)
interval - The maximum time the system waits for a response to general queries.
(Range: 10-31740 tenths of a second)
Default Setting
100 (10 seconds)
Command Mode
Global Configuration
Command Usage
This command applies when the switch is serving as the querier (see
“ip igmp snooping querier” on
page 446), or as a proxy host when IGMP snooping proxy reporting is enabled (see “ip igmp
snooping proxy-reporting” on page 446).
Example
Console(config)#ip igmp snooping vlan 1 query-resp-intvl 20
Console(config)#
ip igmp snooping vlan static
This command adds a port to a multicast group. Use the no form to remove the port.
Syntax
[no] ip igmp snooping vlan vlan-id static ip-address interface
vlan-id - VLAN ID (Range: 1-4093)
ip-address - IP address for multicast group